Table of Contents
Advertisement
S
ETUP
Mounting the Controller Unit
CAUTION
CAUTION
Mounting the
Controller Unit
14
UX 410 I
NSTALLATION
3
Slot the bolts through the installation panel and on through to the EVA
clamping plate (VPN PPL159-417-01-A).
4
Secure the unit with M4 washers and nuts. Tighten the nuts using the
recommended tightening torque of 5.0 kgf cm (0.49 Nm or 4.3 lbf in).
Avoid placing metallic objects at the front and around the card reader.
5
Remove the clear protective screen from the front of the unit.
For non-metallic variants (M159-410-0xx-xxx), the installation panel needs to
•
be plastic material.
For metallic variants (M159-410-1xx-xxx), the installation panel needs to be
•
metallic, and its size has to be at least 1 cm more. Do not start a contactless
transaction before a metallic UX 410 variant is installed correctly on a metallic
panel.
This section shows how to attach the Controller Unit to the installation panel for
stability and security.
Use the following steps to install the Controller Unit:
Mounting the Controller Unit
Figure 6
1
Align the Controller Unit mounting holes to the installation panel holes.
2
Insert four bolts and tighten the nuts using a recommended tightening torque
of 5.0 kgf cm (0.49 Nm or 4.3 lbf in).
G
UIDE
Advertisement
Table of Contents
