Advertisement
ASSEMBLY
10
Connect the hose and regulator to the LP cylinder and place the tank into the tank housing.
LP cylinder is sold separately.
Warning: check the compatibility with the
connections of equipment's fitted upstream (i.e.
cylinder valve) and downstream (i.e. flexible hose)
of the regulator.
1.Ensure the regulator is sealed and in its good
condition of installation, safety and soundness
conditions.
NO ATTEMPT SHOULD BE MADE TO ADJUST THIS
SETTING.
If you have any problems connecting the regulator
to your cylinder, contact your local gas supplier at
once. Device shall be positioned or protected
against direct penetration by any trickling water,
rain, snow, etc.
In normal conditions of use, in order to ensure the
correct operation of the installation, it is
recommended that this regulator is changed within
10 years of the date of manufacture.
Do not move the cylinder during operation.
This regulator is not for use in caravans and motor
caravans.
2.Fitting the Hose
Before connecting the regulator onto the cylinder
valve, take care to fix the supplied flexible gas hose
to the barbed stem (the latter should be lubricated
with some water or liquid soap to facilitate
insertion.)To guarantee a sound connection, use a
jubilee hose clip, which is usually together with the
hose and the clips are standardized.
Contact us for assistance: cservice@welltraveled.net | www.balkenehome.com
3.Mounting the Regulator onto the Gas Cylinder
Ensure all taps on the gas appliances are closed.
Ensure the connecting hose is correctly fitted.
Make sure the regulator is in the closed position with the
tap pointing leftwards:
When installing, please press down the regulator into
the cylinder valve until the black knob pops up.
When exchanging, please press the black knob and pull
up the regulator.
When using, please turn the knob 90°clockwise to place
regulator in the gas-flow state:
Once the regulator is correctly mounted on the cylinder
valve, gas should flow through the regulator to the outlet
hose.
4.Replacing the Gas Cylinder
Turning off the "Clip-on" will disconnect the regulator
from the cylinder valve.
9
Advertisement
