Advertisement
ASSEMBLY
5
Carefully route the Gas Hose
Head and Upper Post Assembly
the Lower Post/Post Support Plate Assembly
Control knob on Head Assembly should be located over the
Tank Housing Door.)
6
Attach Head Assembly and Upper Post Assembly
the Lower Post
E
by aligning the 4 small holes located
on the Upper Post with the 4 small holes located on the Lower
Post. Insert 4 M6x12 Bolts through 4 M6 Lock Washers and into
holes and tighten with a wrench.
Hardware Used: 4x M6x12 Bolt and M6 Lock Washer
7
Assemble
Panels and Center Cap come packaged in two brown
boxes with two panels in each box. Hardware for assembly
adjacent panel. Place the washer over the bolt and screw on
cap nut. Repeat these steps until all four panels are assembled.
Then locate the Center Cap. You will need to remove the cap
to allow assembly of the Center Cap on each panel. Align the
washer and cap nut to complete assembly. (Note: It is easiest to
assemble on a soft surface. Once 4 panels are assembled, turn
Contact us for assistance: cservice@welltraveled.net | www.balkenehome.com
C
that comes attached to
B
completely through
/
. (Hint:
E
F
B
to
.
A
B
C
E
/
F
B
E
A
7
Advertisement
