Advertisement
OPERATING INSTRUCTIONS
LIGHTING
NOTE: For initial start or after any cylinder
change, hold the control knob in for 2
minutes to purge air from all gas lines
before proceeding. NOTE: This heater
has an Electronic Ignition and will require
installation of 1 - AAA battery. The battery
should be installed by unscrewing the RED
IGNITER BUTTON.
1. Turn the control knob to the "OFF"
position.
2. Fully open the LPG cylinder valve.
3. Turn the control knob counterclockwise
4. Push control knob in and then push the
RED igniter button to ignite the main
burner. Repeat until the burner ignites.
Keep the control knob fully pushed in
for an additional 10-20 seconds after
the burner ignites, then release the
control knob.
turn the control knob counter clockwise
6. To turn the appliance OFF, turn the
control knob clockwise to the OFF
position.
7. Wait at least 5 minutes before
attempting to re-light the heater.
8. Turn the gas cylinder valve to OFF or
closed.
If you experience any ignition problems, please consult the "Troubleshooting"
section of this manual.
Caution:
odor from the burning of oils used in the manufacturing will appear. Both smoke
and odor will dissipate after approximately 30 minutes. The heater should NOT
produce thick black smoke.
Contact us for assistance: cservice@welltraveled.net | www.balkenehome.com
Control
Trait de
calibration
graduation
mark
Caution:
Be sure to carefully review
assembly instructions for
proper burner ignition and
general operating and safety standards!
Precaución: Asegúrese de revisar
cuidadosamente las instrucciones de
montaje para un encendido correcto del
calentador, el funcionamiento general y
estándares de seguridad.
Avertissement:
Lire attentivement les directives de
montage pour proceder correctement
a l allumage du bruleur ainsi que les
instructions de fonctionnement et
les consignes de securite!
WARNING
FOR YOUR SAFETY
Be careful when attempting to manually
ignite this heater. Holding in the control
knob for more than 10 seconds before
upon ignition.
WHEN HEATER IS ON:
Emitter screen will become bright
red due to intense heat. The color
is more visible at night. Burner
will display tongues of blue and
not produce thick black smoke,
should be blue with straight yellow
turn off heater and consult the
"Troubleshooting" page.
RE-LIGHTING:
Note: For your safety, the control
knob cannot be turned OFF
control knob and then rotating
to OFF.
1. Turn control knob to OFF.
2. Wait at least 5 minutes to
allow gas to dissipate before
re-lighting.
3. Repeat the "Lighting" steps
listed above.
12
Advertisement
