Advertisement
ASSEMBLY
PREPARATION
Before beginning assembly of this appliance, make sure all parts are present. Compare all parts with package contents list
and hardware contents as listed on page 4 of this manual. If any part is missing or damaged, do not attempt to assemble
this product. Contact Customer Service for replacement parts.
ESTIMATED ASSEMBLY TIME: 60 minutes
Tools Required for Assembly (NOT included):
• Phillips screwdriver w/medium blade
NOTE: This heater has an Electronic Ignition and will require the installation of 1-AAA battery. The battery should be
installed by unscrewing the RED IGNITER BUTTON. The LED control box also requires the use of 8-AA batteries.
BATTERIES ARE NOT INCLUDED.
1
Locate Tank Housing Assembly
Support Bar
H
. Attach Tank Housing Support Bar to the
top front edge of the Tank Housing Assembly with 2x M4x10
Countersunk Head Screws (screws come pre-assembled in
the Tank Housing Support Bar.)
Hardware Used: 2x Countersunk Head Screw M4x10
Sand box assembly: The sand box will come pre-assembled
hardware and remove the sand box. Then remove the plastic
Base down over sand box and insert M8X45 Bolt through hole
in Base and into Tube and M8 Washer. Secure beneath sand
box by tightening M8 Nut onto end of Bolt.
Attach Wheels to Base: Remove M6 Bolt/Lock Washer/Nut
from each Wheel assembly. Align holes in Wheel Assembly
with holes in Base. Insert M6 Bolt through holes and slide on
Lock Washer. Secure with Nut. Hand tighten and then tighten
with Wrench when both Wheels have been secured to base.
Hardware Used: 6 x Bolt/Lock Washer/Nut M6
Contact us for assistance: cservice@welltraveled.net| www.balkenehome.com
• Leak test solution (see page 11) • Adjustable wrench (2) (NOTE: 10mm wrench or
G
and Tank Housing
G
H
5
Advertisement
