Advertisement
ASSEMBLY
8
While supporting heater, tilt the Head and Upper Post
Assembly
B
and screw in the 3 M8x66 Stud Bolts into
the holes on top of the Head Assembly. Slide the assembled
A
over the 3 Stud Bolts that now extend from the
Head Assembly. Use the 3 M8 Wing Nuts and 3 M8 Washers
to secure the assembled
the heater. Once you have tightened the Wing Nuts, return
Hardware Used: 3x M8x66 Stud Bolts
9
Connecting the LED feature:
with LED rope lights preassembled in the base and Post
Support Plate
F
(See Fig.1 and 2).
[NOTE: Before attaching the LED connectors to the LED control
box, you must insert 8 - AA batteries (NOT included) by sliding
the top of the LED control box off to release the top. Once
the top is removed, insert the batteries and then replace the
top by sliding it back down on the box.] Connect both sets of
connectors and control LED feature with On/Off switch located
on LED control box.
Contact us for assistance: cservice@welltraveled.net | www.balkenehome.com
to the Head Assembly of
6x Large Flat Washer | 3x Wing Nut
A
B
8
Advertisement
