Advertisement
ASSEMBLY
2
Attach the Lower Post
using 4 M8x16 Bolts and 4 M8 Washers. (Note: Turn the
post and support plate upside down to secure the bolts.)
Align the Post Support Plate with the holes in the Lower Post,
and insert 1 M8x16 Bolt through 1 M8 Washer and through the
aligned holes. Tighten with a wrench.
Hardware Used: 4x Bolt M8x16
3
Attach the Post Support Plate
the Tank Housing Assembly
FireSense® logo is facing forward directly over the Tank
Housing Support Bar.) Align the holes in the Post Support
Plate with the holes in the top of the Tank Housing Assembly
and insert a total of 12 M4x10 Bolts into the holes and loosely
tighten. Once all bolts have been inserted, tighten with a
wrench.
Hardware Used: 12x Bolt M4x10
4
Attach Tank Housing Door
Assembly
G
by sliding the pins on the side of the door
into the hinges located on the right side of the Tank Housing
Assembly. (NOTE: Make sure you hold door to the SIDE of the
Tank Housing Assembly before trying to align pins. If you hold
door to the FRONT of the Tank Housing Assembly, you will
NOT be able to align pins correctly.)
Contact us for assistance: cservice@welltraveled.net | www.balkenehome.com
E
to the Post Support Plate
4x Washer M8
F
/Lower Post
E
G
/
H
. (NOTE: Make sure
I
to the Tank Housing
F
F
to
E
E
G
/
H
I
F
G
/
H
6
Advertisement
