Siemens MOBILETT XP Digital Troubleshooting Manual page 12

12
Use the initialization code when the normal code in unable to start for some reason or
when you have lost the Ethernet settings. Using the initialization code sets the Ether-
net-related settings to the default settings and allows you to perform the start-up operation
for the initialization code.
In this case, the connection can be made by setting the Ethernet settings in the control PC
to the 50G default (*2).
This default connection allows you to upgrade the firmware again and also to check and
set the Ethernet settings again in order to recover the system.
Fig. 6:
Initialization switch: Switch 1 mounted on PCB-50 XRY
Default settings: IP Address=192.168.100.11 (factory setting)
MOBILETT XP Digital
Power box installation switch
SPR8-230.840.30.03.02
12.05
Imaging system overview
Page 12 of 68
CS SD 24
Siemens AG
Medical Solutions