Daikin iTM plus Installation Manual page 4

• Keep water out of the controller.
• To avoid electric shock due to entry of water or insects, fill the wiring through-
hole with putty.
• Do not wash the controller with water as it may result in electrical shocks or
fire.
• Do not touch the controller buttons with wet fingers.
Touching the buttons with wet fingers can cause an electric shock.
• Do not install the controller in the following locations:
(a) Where a mineral oil mist or oil spray or vapor is produced, for example, in a
(b) Where corrosive gas, such as sulfurous acid gas, is produced.
(c) Near machinery emitting electromagnetic waves.
(d) Where flammable gas may leak, where there is carbon fiber or ignitable dust
(e) High temperature area or directly flamed point.
(f) Moist area, where there is exposure to water.
• Install the control wires for the controller at least 3.5 feet (1 meter) away from
televisions or radios to prevent image interference or noise.
Depending on the radio waves, a distance of 3.5 feet (1 meter) may not be sufficient
to eliminate the noise.
4
kitchen.
Plastic parts may deteriorate and fall off.
Electromagnetic waves may disturb the operation of the control system and cause
the unit to malfunction.
suspensions in the air, or where volatile flammables such as thinner or gaso-
line are handled.
Operating the unit in such conditions can cause a fire.
Heating and/or fire can occur.
If water enters the inside of the controller, it may cause electric shock and electrical
components may fail.
Installation Manual 3P291714-4B
DCM601A72 iTM plus adaptor
CAUTION
NOTE
English