Table of Contents
Advertisement
4.1.1
Setting address with wired remote controller
The operation procedure of the wired remote controller is as follows.
NOTE
After power-on, the controller shows the symbol "
all information on its display. During this period, it may not accept your operation. If so,
try operating the remote controller again after "
1. Press and hold the Inspection/Test Operation button for 4 seconds or more.
<Step 1>
2. "SETTING" appears in the center of remote controller display. Using the Temperature
Setting buttons, change the value shown in the parameter number display area to "00".
In the address display area, the current address setting is displayed. (This area will
show "–" if no address is set.)
<Step 2>
NOTE
If the power is not supplied for the intelligent Touch Manager or iTM plus adaptor, you
cannot change the value to "
Turn on the power supply for both the intelligent Touch Manager and iTM plus adaptor,
and wait for a while before starting the operation.
It should also be noted that you cannot change the value to "
tions between the intelligent Touch Manager, iTM plus adaptor and indoor units is not
performed properly.
Check that all cables are connected correctly.
3. Press the SCHEDULE button to make the "GROUP" indicator blink.
You are now ready to change the DIII-NET address.
<Step 3>
26
F
GROUP
SETTING
00
".
GROUP
SETTING
Installation Manual 3P291714-4B
DCM601A72 iTM plus adaptor
88
" for about 1 minute after displaying
88
" disappears.
HH
00
" if any of communica-
English
Advertisement
Table of Contents
