Electric Wiring - Daikin iTM plus Installation Manual

2

Electric wiring

This chapter describes the procedure for connecting the iTM plus adaptor with intelligent
Touch Manager, DIII-NET-compatible air conditioning devices and other equipment.
In addition to air conditioners, the iTM plus adaptor can be connected and work with a
wide range of equipment. However, the required connection procedures vary depending
on the equipment to be connected.
Do not connect more than two wires to the same terminal.
Required proce- • 2.1 Connecting intelligent Touch Manager
dures
• 2.2 Connecting DIII-NET-compatible air conditioning equipment
• 2.4 Connecting power supply
Equipment-spe- • 2.3 Connecting an emergency stop input device or power meter
cific procedures
• Do not turn on the power supply before all wire connections are completed.
Not doing so may cause an electric shock.
• After the wiring is completed, double-check that all wires are connected cor-
rectly before turning on the power supply.
• All field supplied parts and materials, electric works must conform to local
codes.
• All wiring must be performed by an authorized electrician.
Provide a cable trap before the terminal block and perform wiring to prevent
water entry. Water splashing onto the terminal block may result in an electric
shock or fire.
A
A
B
C
12
WARNING
CAUTION
Terminal block
With trap
Without trap
Installation Manual 3P291714-4B
DCM601A72 iTM plus adaptor
B
C
English