Hendi 274156 User Manual page 5

Main parts of the appliance
1. Pipe holder
2. Fountain pipe
3. Auger
4. Silica gel ring (Ø 24mm)
5. Air-proof ring (Ø 20mm)
6. Base unit
7. FUSE housing
8. Motor / Heater switch
9. Power connector
10. Temperature adjuster
11. Heat dissipation hole
12. Motor axle
13. Seal ring (Ø 220mm)
14. Chocolate pool
Putting the appliance into use
• Check to make sure the appliance is undam-
aged. In case of any damage,
supplier immediately and do NOT use the ap-
pliance.
• Remove all the packing material and protection
film (if applicable).
• Place the appliance on a level and steady sur-
face, unless mentioned otherwise. Two of the
three feet of the base unit can be adjusted in
height to level the appliance.
• Do not place the chocolate fountain near an air-
conditioning duct, open door or window. Cool
air will solidify the chocolate and stop the even-
ly flow of chocolate.
• Make sure there is enough clearance around
the appliance for ventilation purposes.
• Position the appliance in such a way that the
plug is accessible at all times.
• Unpack the chocolate fountain.
• The packaging contains a base unit, a choco-
late pool, a fountain pipe, a pipe holder, a auger,
a seal ring, five silicon seal rings. five air-proof
rings and two fuse(thermal cut-out).
3
14
13
12
11
10
9
• Keep the packaging if you intend to store your
contact your appliance in the future.
• Clean the appliance before use (See ==> Clean-
ing and Maintenance).
• Place the seal ring [13] on the top of round edge
of the base unit[6].
• Screw in the chocolate pool [14] on the base
unit by clockwise.
• Place the auger[3] on the motor axle[12] of the
base unit.
• Place the fountain pipe[2] over and cover the
auger[3] and screw in the fountain pipe[2] on
the base unit[6] by anti-clockwise.
• Place the pipe holder[1] on the top of fountain
pipe[2] and line up the center hole with the top
of auger[3].
• The chocolate fountain is now ready for use.
1
2
4
5
6
7
8
5
EN