Table of Contents
Advertisement
LP GAS HOOK-UP
Follow these steps to connect your LP regulator to the portable LP cylinder:
•
Check to ensure that the tank's gas valve on top of the cylinder is closed.
•
Place LP Cylinder on a level surface in the enclosure below the oven and arranged for vapor with-
drawl.
•
Connect the 3/8" flare end of the hose to the oven coupling using a 3/4" open wrench. Do not ap-
ply pipe sealant on the 3/8" flare connection.
•
Connect the regulator to the LP cylinder and hand tighten it, do not use a wrench.
•
Open the cylinder valve. Check for leaks using soapy water solution. (Reference page 8 for leak
test procedure).
Ensure the gas hose or flex tube is free and clear, if there is any evidence of abrasion, wear,
cuts, or leaks, the hose or tubing must be replaced prior to appliance being put into operation. The re-
placement hose or tubing will be specified by Delta Heat. (See pages 10-11 for how to gain access to
tubing). If the oven is to be stored indoors, disconnect the gas supply cylinder and leave the cylinder
outdoors.
LP REGULATOR
LP CYLINDER
Delta Heat Service (562) 263-3600 | 3
Advertisement
Table of Contents
