Table of Contents
Advertisement
OPERATING INSTRUCTIONS
BEFORE LIGHTING THE PIZZA OVEN
•
DO NOT ATTEMPT TO LIGHT THE PIZZA OVEN IF YOU SMELL GAS.
•
WARNING! IT IS CRITICAL THAT THE GAS BURNERS ARE PROPERLY INSTALLED WITH
THEIR ORIFICES INSIDE THE BURNERS AIR SHUTTERS. If not properly installed, gas
may leak outside of the burner that could lead to fire, potential damage to your grill, bodi-
ly injury or death.
•
Inspect the gas supply piping or hose prior to turning the gas ON. If there is evidence of cuts,
wear, or abrasion, it must be replaced prior to use. The replacement pressure regulator and hose
assembly must be the type specified by the manufacturer. Do not use the oven if the odor of gas
is present. The pressure regulator and hose assembly supplied with the unit must be used.
•
If the unit is LP, hand tighten the regulator to the valve of the cylinder and leak check the hose
and regulator connections with a soap and water solution before operating the grill. Reference
page
8
for leak test procedure.
•
Always keep your face and body as far away as possible when lighting.
•
Refer to Spiders and Insects warning and procedure under the Cleaning and Maintenance page
of this manual.
TO LIGHT THE OVEN BURNERS
Follow the steps below to light your Pizza Oven:
1. Open the oven doors completely. Do not attempt to light the oven with the doors closed.
2. Open the gas supply shut-off valve.
3. Push in the knob for five seconds and verify that the hot surface igniter glows bright orange for
both the hearth burner and the rear burner. If the igniter does not glow, verify unit is plugged
into power source. If still no glow is emitted, a new igniter may be required.
4. Once the glow is verified, turn the knob counterclockwise 90° to the biggest flame marking on
the knob. Hold the knob pushed in until the burner lights. Once burner lights continue to hold
knob for 10-20 seconds or until the burner stays lit.
NOTE: To verify the glow of the hearth igniter, on the front
panel, slide the matchlight tube cover to the left to expose
the tube. Look through this tube to verify the glow of the
hearth igniter.
CAUTION: If ignition does not immediately take place, turn
knob to the OFF position, wait for five minutes and repeat
the lighting procedure.
5. Close the doors to allow the oven stones to pre-heat
until the desired stone temperatures are acquired.
14 | www.deltaheat.com
Advertisement
Table of Contents
