Table of Contents
Advertisement
Burner set to LP
The Air Shutter may be adjusted while the burner is installed in the unit. With the Rear Access
Panel removed, loosen the adjustment screw and gently open or close the Air Shutter to adjust the
flame for the Rear Burner. The Rear Burner flame should be yellow and virtually silent.
If the flames do not match those above, remove the burner and verify that the burner is clean
by follwing the guidelines outlined in Cleaning and Maintenance on pages 20-21.
AIR SHUTTER DETAIL
Flames should be in
a range of heights
from 1" to 5"
Air Shutter Adjustment
Screw
Burner set to NG
Delta Heat Service (562) 263-3600 | 11
Advertisement
Table of Contents
