Table of Contents
Advertisement
RECOMMENDED APPLIANCE AND CYLINDER PLACEMENT
The cylinder should be placed in such a
way that it cannot strike the unit when fall-
ing to the ground.
Cylinder and hose are placed away from
the hot body of the oven.
For your safety, please consider the following:
1. When an LP cylinder is placed close to the unit, a tripping hazard with the hose or cylinder might
occur.
2. The length of the hose and the location of the cylinder must not interfere with the unit operation
and if it was to fall to the ground, it will not strike the unit on its downward fall or pull the unit suffi-
ciently to cause spillage of liquids or food, should the cylinder be tipped in any direction.
3. Connect and disconnect the hose according to the steps on page 3. Ensure the connections are
tight, leak test each connection. (Reference page 8 for Leak Test)
4. If the Pizza Oven is not in use, disconnect the cylinder from the Oven. Ensure the valve on the
cylinder is turned off before disconnecting from the unit.
5. If the Pizza Oven is to be stored for long periods of time, the cylinder must be disconnected from
the unit before storage.
6. Cylinders are to be stored outdoors, out of reach of children, and shall not be stored in a building,
garage, or any other enclosed area.
7. The LP cylinder should be placed upright for vapor withdrawal only. Never place the cylinder on its
side or upside down.
8. The cylinder must be equipped with a collar to protect the cylinder valve at all times.
DO NOT place the cylinder in such a way that
it becomes a tripping hazard or it could be
tipped.
The cylinder could drag the unit and fall to the
ground while operating.
Delta Heat Service (562) 263-3600 | 7
Advertisement
Table of Contents
