Netvanta 900 Series Octal Ethernet Switch Module (P/N 1200793L1); Figure 9. Netvanta 900 Series Octal Ethernet Switch Module - ADTRAN NetVanta 900 Series Hardware Installation Manual

Modules

NetVanta 900 Series Octal Ethernet Switch Module (P/N 1200793L1)

The Ocatl Ethernet Switch Module (shown in Figure 9) provides eight 10BaseT/100BaseTX (RJ-48C)
interfaces for connection to local area networks (LANs). Each interface supports auto-negotiation and
provides auto MDI/MDIX crossover. Refer to Table A-7 on page 37 for the Ethernet connector pinout.

Figure 9. NetVanta 900 Series Octal Ethernet Switch Module

24
Features and Specifications
Interfaces
• (8) 10BaseT/100BaseTX interfaces supporting auto-negotiation and auto
MDI/MDIX crossover
Note: Auto-negotiation must be enabled on a specific port to allow
auto MDI/MDIX crossover to function on that port.
• Maximum of 41 system LAN interfaces with Ethernet Switch Modules
installed in Slots 2 through 6 of the chassis (40 available interfaces in the
five Ethernet Switch Modules and 1 interface in the controller)
• The Ethernet Switch Module acts as a stand-alone switch if installed in
Slot 7 of the chassis.
VLAN Support
• Port-based VLANs
• 802.1Q tagged trunked VLANs
• Support for up to 510 active VLANs
Flow Control
• Back-pressure flow control on all half-duplex interfaces
• Pause-frame flow control on full-duplex interfaces
Agency Approvals
• FCC Part 15, Class A
• UL 60950, Third Edition/CS C22.2, No. 60950
Environmental
• Operating Temperature: 0°C to 50°C
• Storage Temperature: -20°C to 70°C
• Relative Humidity: 95% noncondensing
© 2004 ADTRAN, Inc.
NetVanta 950 IAD Hardware Installation Guide
61200788L1-34B