Installation; Safety Instructions For Installation - Miele ProLine CS 1018 G Operating And Installation Instructions

Installation

Safety instructions for installation


Risk of damage from incorrect connection.
Incorrect installation can cause damage to the ProLine element.
The ProLine element must only be installed by a qualified person.

Damage from falling objects.
Take care not to damage the ProLine element when fitting wall units or a cooker
hood above it.
Fit the wall units and the cooker hood before the ProLine element.

The room in which the ProLine element is installed must conform
to all relevant local and national building and safety regulations.

The veneer or laminate coatings of worktops (or adjacent kitchen
units) must be treated with 100 °C heat-resistant adhesive which will
not dissolve or distort. Any backmoulds must be of heat-resistant
material.

A deep fat fryer must not be installed directly next to a gas hob or
a wok burner as the gas flames could ignite the fat in the fryer. It is
essential to maintain a distance of at least 288 mm between these
two appliances.

The ProLine element must not be installed over a fridge, fridge-
freezer, freezer, dishwasher, washing machine, washer-dryer or
tumble dryer.

When installing the ProLine element, make sure that the gas pipe
and mains connection cable cannot come into contact with hot
appliance parts.

The mains connection cable and any flexible gas connection pipes
must be installed in such a way so that they do not come into
contact with any moving kitchen parts (e.g. a drawer) after the
ProLine element has been installed, and that they cannot be
subjected to any mechanical action which could cause damage.

Observe carefully the safety clearances listed on the following
pages.
38