General Procedure; Unpacking The Device - Siemens SIMATIC NET RUGGEDCOM RSG908C Installation Manual

Installing the Device
2.1 General Procedure
of a tool, lock and key, or other means of security, and controlled by the authority
responsible for the location.
2.1

General Procedure

The general procedure for installing the device is as follows:
Note
The user is responsible for the operating environment of the device, including
maintaining the integrity of all protective conductor connections and checking
equipment ratings. Make sure to review all operating and installation instructions
before commissioning or performing maintenance on the device.
1.
2.
3.
4.
5.
6.
2.2

Unpacking the Device

When unpacking the device, do the following:
1.
2.
3.
Note
If any item is missing or damaged, contact Siemens for assistance.
6
Review the relevant certification information for any regulatory
requirements.
For more information, refer to
Unpack and inspect the device.
For more information, refer to
Mount the device.
For more information, refer to
Connect the failsafe alarm relay.
For more information, refer to
12)".
Connect power and ground the device.
For more information, refer to
Configure the device.
For more information, refer to
Inspect the package for damage before opening it.
Visually inspect each item in the package for any physical damage.
Verify all items are included.
"Approvals (Page 31)".
"Unpacking the Device (Page
"Mounting the Device (Page
"Connecting the Failsafe Alarm Relay (Page
"Connecting Power (Page
"Configuring the Device (Page
Installation Manual, 04/2022, C79000-G8976-1404-11
6)".
8)".
14)".
22)".
RUGGEDCOM RSG908C