Dhw And System Set Point Configuration - Ferroli OMNIA S HYBRID H 3.2 Installation, Use & Maintenance Manual

8.4 DHW and system set point configuration

SW6
SW1 SW3
SW4
SW2
SW7
SW5
NOTE
The icon indicates which setpoint is being
modified
50
EN
DHW set point (min 30°C, max 60°C)
To change the DHW set point, proceed as follows:
• press the SW1/SW2 buttons to select the set point
• press the SW6/SW7 buttons to change the set point
• confirm the modified value with the SW3 button
Single zone set point
Heat setpoint (min:max)
Type of terminal selected
FLH (radiant floor)
FCU (fancoil) / RAD (radiator)
To change the single zone set point, proceed as follows:
• press the SW1/SW2 buttons to select the set point
• press the SW6/SW7 buttons to change the set point
• confirm the modified value with the SW3 button
Zone Z1 set point
Heat setpoint (min:max)
Type of terminal selected
FLH (radiant floor)
FCU (fancoil) / RAD (radiator)
To change the zone Z1 set point, proceed as follows:
• press the SW1/SW2 buttons to select the set point
• press the SW6/SW7 buttons to change the set point
• confirm the modified value with the SW3 button
Zone Z2 set point
Heat setpoint (min:max)
Type of terminal selected
FLH (radiant floor)
FCU (fancoil) / RAD (radiator)
To change the zone Z2 set point, proceed as follows:
• press the SW1/SW2 buttons to select the set point
• press the SW6/SW7 buttons to change the set point
• confirm the modified value with the SW3 button
Cod. 3542B230 - Rev. 00 - 02/2022
OMNIA S HYBRID H 3.2
Cool setpoint (min:max)
25: 55 18: 25
25: 65 5: 25
Cool setpoint (min:max)
25: 55 18: 25
25: 65 5: 25
Cool setpoint (min:max)
25: 55 18: 25
25: 65 5: 25
Z1
Z2