Before The First Use; Temperature Setting; Water Tank Filling - Fakir SPRING Manual

Before The First Use

Some parts of the steam iron have been slightly greased and as a result the iron may
slightly smoke when switched on for the first time. After a short time this will cease.
Remove protection cover from the soleplate and clean it with a soft cloth.
Label Type Of Textile
Do not iron this article
Synthetics, Nylon, Acrylics, Polyester, Rayon
Wool, Silk
Cotton, Linen
Insert the main plug into the wall socket. The indicator light will turn on. When the
indicator light goes out you may start ironing. If you set the temperature control to lower
setting after ironing at a high temperature, it is not recommended to iron before the pilot
light switches on again.
NOTE!
Your steam iron is designed to use tap water, however,
if the water is very hard, it is advisable to use distilled
water. The water tank should be emptied after each
use.
SPRING

Temperature Setting

Always check whether a label with ironing instructions is
attached to an article to be ironed. Follow these instructions in all
cases. Turn the temperature control dial round to set the
appropriate temperature indicated in ironing instructions or in
fabric label.

Water Tank Filling

Unplug the iron before filling the water tank. Hold the steam iron
in horizontal position. Slowly pour water through the water inlet.
Do not fill higher than mark on the water tank, in order to avoid
spilling out of water.
19
EN