Table of Contents
Advertisement
DEVELOPMENT SECTION
23. Wait 5 minutes to ensure that no residual voltage remains on the drum.
NOTE: The process control self check (step 28) must be performed
when there is no residual voltage on the drum.
24. Open SP Special Feature P-1.
25. Confirm that the PID key [C] is selected for the Process Control Mode
Selection. If not, touch the PID key [C].
26. Touch the Index key [D].
27. Open SP Test Mode P-4 (Process Control Self Check).
28. Touch the Process Control Self Check Start key [C]. After the self check
is completed, the machine stops automatically.
CAUTION
While process control is taking place, do not touch the knob, drum
stay, or drum shaft. These parts and the fly wheel carry a high voltage
during process control.
29. Touch the Index key [D].
[C]
[C]
5-18
10 May 1996
[D]
[D]
Advertisement
Table of Contents
