Table of Contents
Advertisement
COPIER (A172/A199)
[B]
[H]
[D]
[G]
[E]
[F]
12. Carefully pull and remove the transfer belt unit [A]. (While holding the
handle [B], release the lever [C])
NOTE: There are stands at the rear side of the transfer belt unit. After
pulling out the unit out of the machine, stand the transfer belt unit
as shown.
Do not touch the transfer belt surface with bare hands.
13. Remove the charge corona unit [D] (1 screw, 1 connector), PCC [E] (1
screw) and ID sensor board [F] (1 screw).
14. Remove the knob [G] and the two screws [H] and pull out all the
development units slightly (2 ∼ 3 cm) then remove the drum stay [I].
[C]
[A]
A172I516.img
[I]
[H]
A172I518.wmf
3-10
10 May 1996
A172I517.img
Advertisement
Table of Contents
