Table of Contents
Advertisement
10 May 1996
3. Install the interface board and harness.
[C]
[A]
[F]
1. If the DJF is equipped on the copier, secure the DJF to the scanner unit
with the DJF fixing belt [A] as shown.
If the Film Projector Unit is installed on the copier, remove the mirror unit.
2. Remove the two fixing screws [B] at the front of the scanner unit.
3. Remove the two fixing screws [C] at the rear of the scanner unit.
4. Open the scanner unit and set the scanner support bar [D] as shown.
5. Disconnect the shielded flat cable [E] and remove the IPU board cover [F]
(2 long and 5 short screws).
6. Remove the harness cover [G] from the right rear corner.
7. Remove the lower rear cover [H] (6 screws) and the lower left cover [I] (4
screws). Then remove the cap [J] from the lower left cover.
[B]
[D]
A583I503.img
CONTROLLER INTERFACE TYPE-C (A583-05)
[G]
[E]
[H]
3-55
[I]
[J]
A583I504.img
Advertisement
Table of Contents
