Table of Contents
Advertisement
10 May 1996
Error information
(i) Message after the test
(a) If the test is successful:
•
[Test Successful] appears at the center of the screen.
(b) If the test is unsuccessful:
•
[Test Failed] appears at the center of the screen.
•
Error information appears at the lower left-hand corner of the screen.
Remarks: Error information
Error plane
Error segment
Error offset
Check data
Error data
(ii) Processing after the test
(a) If the test is successful:
•
Test mode: The system executes the next test.
•
Continuous mode: The system repeats the same test.
•
Execution mode: The system displays [Menu].
(b) If the test is unsuccessful:
•
The system displays the error message and [Menu].
You must press [Menu] to return to the menu screen.
OPERATION PANEL SELF-DIAGNOSTIC MODES
Video RAM Read/Write Test
: ΘΘΘΘ
E R R O R P L A N E
E R R O R S E G M E N T : ΘΘΘΘ
: ΘΘΘΘ
E R R O R O F F S E T
: ΘΘΘΘ
C H E C K D A T A
: ΘΘΘΘ
E R R O R D A T A
Test Count : ΘΘΘΘ
Memory bank at switching time
Segment (A000h or B000h) is displayed.
A value from 0000h through FFFFh is displayed.
Value written at test execution time
Value read from the same position that was written into
You must press [Menu] to return to the menu screen.
Test result message
If the test is a success, [Test successful]
appears.
If it is not, [Test Failed] appears.
Θ Θ Θ Θ
[Menu] key.
You must press this key to return to
the menu screen.
6-41
Menu
Advertisement
Table of Contents
