Manual Cancellation Of The Auto Fill Function; Manual Mode; Switching To Manual Mode; Switching Back To Automatic Mode - Protec COMPACT 2 Instructions For Use Manual

Automated x-ray film processor
Table of Contents

Advertisement

V6.0_2021-05-25
3
Filling developer and fixer tank: Keep both replenishment buttons for developer (7) and fixer (8)
pressed down and switch the machine on or filling developer or fixer tank: Keep respective
replenishment button (7 or 8) pressed down and switch the machine on.

4.1.16.2 Manual cancellation of the auto fill function

1
Stop developer tank filling: Keep developer replenishment button (7) pressed down and press
"arrow down" button (3).
2
Stop fixer tank filling: Keep fixer replenishment button (8) pressed down and press "arrow
down" button (3).
The filling of the water bath will be stopped once the automatic filling of both chemicals baths has
been stopped.

4.1.17 Manual mode

In the manual mode, the processor works without the light barrier. The film transport must be started
and stopped manually. All the set values in the manual mode are also valid in the automatic mode.
Please note that the Infeeding-film-display ("– –") is deactivated. In the Manual Mode the replenishment
function does not use film surface measurement, instead it uses a standard value. In the manual mode,
a replenishment cycle can also be activated manually.

4.1.17.1 Switching to manual mode

Switch the machine on. During stand-by, press the arrow-buttons "up" (2) and "down" (3)
simultaneously. When in manual mode the display is flashing.

4.1.17.2 Switching back to automatic mode

In manual mode with film transport off press both arrow-buttons "up" (2) and "down" (3)
simultaneously.

4.1.17.3 Manual starting and stopping the film transport

1
Switch to manual mode
2
Press the processing time button (4) – the button illuminates
3
Start the film transport by pressing the arrow-button "up" (2) or stop the film transport by
pressing the arrow-button „down" (3)

Manual replenishment

4.1.17.4
1
Switch to manual mode
2
Press required replenishment button for developer (7) or fixer (8) – respective button
illuminates
3
Start the replenishment cycle by pressing the arrow-button „up" (2) or cancel the
replenishment cycle by pressing the arrow-button „down" (3)

4.1.18 Use of memory function

In the memory five sets of parameters can be stored and be recalled into working memory.

4.1.18.1 Store processing parameters

1
Set machine to preferable parameters e.g., bath temperature, processing time etc. (see
manual).
2
Press buttons 4 and 5 "Enter Memory" simultaneously to enter the memory mode.
3
Use buttons 2 and 3 "Select" to select the parameter memory (P1 to P5). Inside this the
parameters will be stored, old values will be overwritten.
Press button 5 "Store" to store parameters and to leave the memory mode.
4

4.1.18.2 Recall processing parameters

1
Press buttons 4 and 5 "Enter Memory" simultaneously to enter memory mode.
2
Use buttons 2 and 3 "Select" to select the parameter memory (P1 to P5) from which the
parameters shall be recalled.
3
Press button 4 "Recall" to recall parameters (copy into working memory) and to leave the
memory mode.
PROTEC GmbH & Co. KG, In den Dorfwiesen 14, 71720 Oberstenfeld, Germany
COMPACT 2 Instructions for use
5190-0-0002
21 of 35

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the COMPACT 2 and is the answer not in the manual?

This manual is also suitable for:

Compact 2 mammo

Table of Contents