Emerson Rosemount 708 Quick Start Manual page 14

Quick Start Guide
Procedure
1. Locate the Rosemount 708 Transmitter on a horizontal section of
piping as close as possible to the equipment to be monitored. Align
the waveguide of the transmitter as shown in
2. Ensure the mounting location is free of foreign matter and corrosion
to ensure good contact between the piping and waveguide.
3. Tighten each clamp to 10.2 N-m (90 in-lb). Trim the excess clamp
band material to prevent unwanted acoustic noise.
4. If commissioning the device, install the power module (see
module).
5. Ensure the power module cover is fully tightened to prevent
moisture ingress. The lip of the polymer power module cover should
be in contact with the surface of the polymer enclosure to ensure a
proper seal. Do not over tighten.
Example
Figure 4-4: Transmitter Orientation
Figure 4-5: Power Module Installation
14
June 2022
Figure 4-4
Power
Emerson.com/Rosemount