Advertisement
SP EA KER I NS T A LLA T I ON
Step #1: Remove the bikes seat, and undo the main (+ and -) connectors from the
battery. Remove the outer fairing/headlamp assembly and set aside.
Refer to a service manual if you need help with this. NOTE: Placing a
towel on the front fender can help prevent scratches or "dings" from
dropped tools or fasteners, etc.
Step #2: Grill Trim Ring Selection:
In the box, you will see that the metal mesh grill with tweeter in it is
sitting in the black trim ring. If you turn this over, you will see "tabs" in
the metal mesh used to secure the mesh to the black trim ring have not
been folded over. These were left unfolded in case you want to remove
the mesh, and have your black trim rings customized, or if you want to
place the metal mesh in the chrome trim rings that also came in the box.
No matter which trim rings you choose, the metal mesh grill with tweeter
must be properly "seated" in the trim ring and all 6 metal mesh "tabs"
must be folded over before proceeding.
Step #3: Removing the Factory Grills:
Each factory grill will be removed from the inner fairing by prying up
on them. Start with your fingers, but if you must use a tool, please use
something with a 90° end being extra careful not to scratch your inner
fairing...especially if its painted! On the back of each grill, there is a
rubber gasket and 2 white clips which will be removed from the factory
grills and re-installed on the Wild Boar Audio grills.
se ct io n 1
NOTE: The factory clips must be removed carefully!
Using your thumbnails or a flat edge under each side,
gently pry the 2 ends apart (as per the image) and pull
up to release each clip from the stock grill. If you put a
flat edge under one end only, the clip cannot release
and you have a very good chance of breaking the clip.
2
Advertisement
