Related Manuals for Hogtunes NCA 450-RM
Summary of Contents for Hogtunes NCA 450-RM
- Page 1 450-RM nca 450-RM 2 0 0 W a t t 4 - C h a n n e l A m p l i f i e r 2 0 0 W a t t 4 - C h a n n e l A m p l i f i e r...
- Page 3 (3, 4, 6 or 8 ohm) will reduce the amplifier’s power output! The NCA 450-RM is rated for 50 watts per channel using 2 ohm speakers at 14.4 volts at 1% Total Harmonic Distortion (THD). Although this amplifier makes its highest power with 2 ohm speakers, if Hogtunes 5.75 ohm speakers or 4 ohm car speakers are used there will still be a noticeable improvement in volume and sound quality.
-
Page 4: Installation Instructions
installation instructions Step #1: Remove the seat and both wires (+ and -) from the battery. Step #2: Remove your outer fairing/headlamp assembly and set aside. Refer to a service manual if you need help with this. NOTE: Placing a towel or something similar on the front fender can help prevent “dings”... - Page 5 Step #5: Sit the supplied silver plate on top of the radio as shown in Fig 1.2. Locate and install one of the supplied “star” washers on each factory screw and re-install the screw/washer through the silver plate, through the factory black plate and into the top of the radio.
- Page 6 Step #6: Sit the amp on top of the silver plate so when standing in front of the bike you can read the Hogtunes logo on top of the amp. Re-install the amp to the plate using the four screws removed earlier.
- Page 7 One side of the plug has wires that go to each rear speaker pod. Separate this large factory plug. One plug from the Hogtunes rear harness will plug into each side of the factory plug just separated. They will only go together one way.
- Page 8 Step #3: Attach the amp’s red wire to the positive (+) battery terminal and the amp’s black wire to the negative (-) battery terminal. The factory battery wires are also re-installed at this point. When attaching the power and ground wires, it is always a good practice to do the negative first. When the positive connector touches the battery, some sparking is normal.
-
Page 9: Technical Specifications
AVC position works and sounds best. Your new amplifier has been specifically set-up for this radio setting. 2) Your Hogtunes system is designed specifically for a motorcycle at speed. Exhaust noise and wind noise have been taken into careful consideration in how your system performs. -
Page 10: Warranty Information
WarrantY inforMation Please Record Your Amplifier’s Serial # Here_________________________ The NCA 450-RM Amplifier is warranted for 3 years from original purchase date. Proof of purchase is required for all warranty claims. The warranty applies to the original retail customer and is not transferable. Please contact Hogtunes for all warranty claims. - Page 12 Hogtunes products will play much louder than the Original Equipment, which can be a distraction to the rider and/or passenger. Please use caution when adjusting or playing your stereo at high volume, especially in traffic. You are a valued customer so please:...
Need help?
Do you have a question about the NCA 450-RM and is the answer not in the manual?
Questions and answers