Replacing A Label Roll - Novexx Solutions ALX 73 Series User Manual

S
TARTUP AND OPERATION

Replacing a label roll

Detecting end of roll
To keep downtimes during production as short as pos-
sible, the roll should be changed as quickly as possible.
Threading the label material through the entire machine
is relatively time consuming. Threading in can be avoid-
ed by connecting the beginning of the new material roll
to the end of the old material roll (= splicing). This
means that the material end must be detected before it
is too late.
Various functions are provided for detecting the materi-
al end; see section Material end / roll diameter 
page 25.
Remove wound carrier material
1. Press in the unlocking button [22B].
The rewider's spreading mechanism is loosened.
2. Remove wound backing paper.
Insert a new label roll
1. Insert a label roll; see section
roll  on page 4.
2. Connect the material beginning of the new roll [23A]
with the material beginning of the used material
[23B] (adhesive tape).
3. Press the Enter key to confirm the error message.
4. Tighten the label web. To do this press the dispens-
er dancer lever down and turn the dispenser back-
wards.
5. Feed the splicing point forward until it has passed
the dispensing edge. To do so, press the feed key
at the printer and afterwards the
penser.

Printer: Slightly pull the label web out of the
printer while feeding it, otherwise the web could
jam.

If labels are missing, the gaps must also be fed
past the dispensing edge.
6. Printer: Press the Feed key to continue the print
job.
User manual ALX 73x | file version 05 | 04/2013
on
Inserting the label
[22] Backing paper rewinder.
key at the dis-
[23] Connect beginning (A) and end (B) of material.
A
B
A Wound backing paper
B Unlocking button
ALX
73x
GB
A
B
Inserting label material | 11