Table of Contents
Advertisement
Chapter 3. Changing the Settings
3.1 Using the Emulator without the Target System
How to use the emulator without the target system is shown below.
(1) Set the "MCU power supply selection jumper" to INT side (see page 20).
3.2 Using the Emulator with the Target System
How to use the emulator with the target system is shown below.
(1) Set the "MCU power supply selection jumper" to EXT side (see page 20).
(2) Connect the target system (see page 22).
(3) Connect the power supply for the emulator (see page 23).
3.3 Using the P8
/X
7
How to use the emulator when using the P8
(1) Set the "P8
3.4 Using the P8
/X
7
How to use the emulator when using the P8
(1) Set the "P8
When using the emulator without the target system, set the "MCU power supply selection jumper"
to INT side. The target MCU operates with 3.3 V of power supply voltage supplied from the
emulator.
When using the emulator with the target system, set the "MCU power supply selection jumper"
to EXT side.
Connect the LCC probe on the lower board of the emulator to the LCC socket (option) or the pitch
converter board (option).
As the emulator cannot supply power to the target system, provide the target system with a
separate power supply from that of the emulator.
Pin as a Port
CIN
/X
selection switch" to PORT side (see page 20).
7
CIN
When using the P8
/X
7
CIN
Pin as Sub-Clock Input
CIN
/X
selection switch" to XCIN side (see page 20).
7
CIN
When using the P8
/X
7
CIN
/X
pin as a port is shown below.
7
CIN
pin as a port, set the "P8
/X
pin as sub-clock input is shown below.
7
CIN
pin as sub-clock input, set the "P8
( 28 / 52 )
/X
selection switch" to PORT side.
7
CIN
/X
selection switch" to XCIN side.
7
CIN
Advertisement
Table of Contents
Troubleshooting
