Table of Contents
Advertisement
Replacing a USB Interface (Front) Assembly (for PureFlex
systems only)
1. Prepare the 7226 Storage Enclosure for Service. See
of a Storage Device or Other Component
2. Open the 7226 Storage Enclosure for Service. See
procedure.
3. Locate the Interface assembly to be replaced.
4. Remove the USB Interface (Front) Assembly (only available on PureFlex systems) by pressing down on the catch located
on the top and bottom of the bezel.
Figure 1. Remove USB Interface (Front) Assembly
5. Remove the USB Interface (Front) Assembly from the drive connector 1 and remove the power connector 2 .
Figure 2. Remove Interface Assembly
6. Locate the new USB Interface (Front) Assembly.
7. Insert the USB cable through the opening in the chassis before snapping the bezel into place to attach the USB
Interface (Front) Assembly (only available on PureFlex systems).
Preparing the 7226 Storage Enclosure for Removal or Installation
for the correct procedure.
Opening the 7226 Storage Enclosure for Service
IBM 7226 Model 1U3 Storage Device Enclosure 51
for the correct
Advertisement
Table of Contents
