Connecting To A 100-Pin 0.65-Mm-Pitch Foot Pattern (Part 3) - Renesas M3062PT-EPB User Manual

3.6.5 Connecting to a 100-pin 0.65-mm-pitch Foot Pattern (Part 3)

Here following is a procedure of connecting to a 100-pin 0.65-mm-pitch foot pattern on the target system
using the M3T-FLX-100NRB (not included). For details on the M3T-100LCC-DMS (not included) and
M3T-FLX-100NRB, refer to each user's manual.
(1) Attach the M3T-FLX-100NRB to the target system.
(2) Attach the M3T-100LCC-DMS to the M3T-FLX-100NRB.
(3) Attach the CN2 side of the M30800T-PTC to the J4 side of the M3062PT-EPB.
(4) Attach the M30800T-PTC to the M3T-100LCC-DMS.
Figure 3.16 Connecting to a 100-pin 0.65-mm-pitch foot pattern (Part 3)
Notes on Connecting the Target System:
These corners are not round.
* Available in one package
• Take care not to attach a converter board in a wrong direction. It may cause a fatal
damage to the emulator and targets system.
• The connectors of the M30800T-PTC are guaranteed for only 50 insertion/removal
iterations.
• The connectors of the M3T-100LCC-DMS and M3T-FLX-100NRB are guaranteed
for only 20 insertion/removal iterations.
( 39 / 80 )
M3T-FLX160-EPB
M3062PT-EPB
CN2 side
(3)
M30800T-PTC
M3T-100LCC-DMS (not included)
(4)
M3T-FLX-100NRB (not included)
(2)
YQSOCKET100RBF
*
YQPACK100RB
NQPACK100RB
100-pin 0.65-mm-pitch (100P6S) foot pattern
(1)
No. 1 pin
Target board
CAUTION
The HQPACK100RB cannot be used.
Please use the HQPACK100RB168.
Evaluation with
actual MCU
HQPACK100RB
(not included)
MCU with flash
ROM etc.