Table of Contents
Advertisement
Caution to Be Taken for Modifying This Product:
• Do not modify this product. Modifying or disassembling this product will void your warranty.
Cautions to Be Taken for Turning On the Power:
• Turn on the power of the emulator and target system as simultaneously as possible.
• Turn off the power of the emulator and target system as simultaneously as possible.
• Do not leave either the emulator or target system powered on, because of leakage current the
internal circuits may be damaged.
• When turning on the power again after shutting off the power, wait about 10 seconds.
Cautions to Be Taken for Handling This Product:
• Use caution when handling the main unit. Be careful not to apply a mechanical shock.
• Do not touch the connector pins of the emulator main unit and the target MCU connector pins. Static
electricity may damage the internal circuits.
• Do not pull this product by the flexible cable for connecting to the emulator main unit and emulation
probe. The cable may cause a break.
• Do not flex the flexible cable for connecting to the emulator main unit and emulation probe
excessively. The cable may cause a break.
• Do not use inch-size screws for this equipment. The screws used in this equipment are all ISO
(meter-size) type screws. When replacing screws, use same type screws as equipped before.
Caution to Be Taken for Malfunctions:
• If the emulator malfunctions because of interference like external noise, do the following to remedy
the trouble.
(1) Press the system reset switch on the emulator front panel.
(2) If normal operation is not restored after step (1), shut OFF power to the emulator once and then
Caution to Be Taken for External Trigger Input Voltage:
• Keep an external trigger input voltage of the emulator main unit less than a Vcc2 voltage.
Overvoltage may cause damage to the internal circuits.
CAUTION
reactivate it.
( 10 / 80 )
Advertisement
Table of Contents
