Note On The Work Area; Note On Map References And Settings; Note On Accessing Sfr Area; Note On Commands That Access The Single-Step Interrupt Vector Area - Renesas M302N1 User Manual

Note on the Work Area:

• When using this product, set to "2C00h" as a start address of the work area at the time of starting
up the emulator debugger (set by "F/W and Work Area" tab*
emulator system uses the area below as a work area.

Note on MAP References and Settings:

• When starting up the M30200T-RPD-E, initial MAP settings are as follows. Use generally the
M30200T-RPD-E in this setting.

Note on Accessing SFR Area:

• Access the below four registers by byte. They cannot be correctly accessed by word.

Note on Commands that Access the Single-step Interrupt Vector Area:

• Do not perform the below debugging operations with the single step interrupt vector area (addresses
FFFECh - FFFEFh).
(1) Step execution of commands that access the single step interrupt vector area
(2) Program execution using commands that access the single step interrupt vector area when a
IMPORTANT
02C00h - 02C0Fh: Work area
00000h to 003FFh: "EXT"
00400h to FFFFFh: "INT" (emulation memory available)
003FCh: Pull-up control register 0 (PUR0)
003FDh: Up control register 1 (PUR1)
003FEh: Port P1 drive capacity control register (DDR)
003FFh: Up control register 2 (PUR2)
software breakpoint is set in those commands
*1 Supported by M3T-PD30 Ver.4.00 or later
( 11 / 38 )
1
of Init dialog). In this case, the