Connecting The M30200T-Rpd-E - Renesas M302N1 User Manual

3.3 Connecting the M30200T-RPD-E

The emulation pod for M302N1 and M302N2 Group MCUs consists of the two products, the
M30200T-RPD-E emulation pod and the M302N2T-PRB pod probe. Figures 3.3 and 3.4 show how
to connect the M30200T-PRB and how to remove it, respectively.
Figure 3.3 Connecting pod probe M302N2T-PRB
Figure 3.4 Removing pod probe M302N2T-PRB
When Connecting Pod Probe:
• Be sure to turn off the power before making connections. Otherwise, the internal
circuits may be damaged.
• The small connectors of the FLX64-PRB (J3 and J4) and M302N2T-PRB (J1 and
J2) are guaranteed for only 50 insertion/removal iterations.
( 20 / 38 )
(1) Connect the J1 and J2 connectors of the M302N2T-
PRB to the J3 and J4 connectors of the FLX64-PRB.
(2) Fix the FLX64-PRB by the two screws.
(1) Unscrew the two screws of the M302N2T-PRB.
(2) Remove the M302N2T-PRB from the FLX64-PRB. In
this time, lift off the M302N2T-PRB horizontally.
Otherwise, the connector may cause a break.
CAUTION