Table of Contents
Advertisement
Figure 51. Removing the optional optical drive
Next step
1
If applicable,
replace the optical drive.
Installing the optional optical drive
Prerequisites
The procedure for installing an optical drive and optical drive blank.
1
Follow the safety guidelines listed in the
2
Follow the procedure listed in the
3
Remove the front
bezel.
4
Remove the air
shroud.
5
If installed, remove the optical drive blank.
NOTE:
The procedure to remove the optical drive blank and the optical drive is similar.
Steps
1
Align and slide the optical drive into the slot until the release tab snaps into place.
2
Connect the power and data cables to the connectors on the optical drive.
NOTE:
Route the cables properly to prevent them from being pinched or crimped.
80
Installing and removing system components
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
