What This Chapter Contains; Configuring Your High Speed Counter Module; Rslogix 5000 Configuration Software - Rockwell Automation Allen-Bradley ControlLogix 1756-HSC User Manual

W hat This Chapter Contains
Configuring Your High
Speed Counter M odule
1
Configuring the ControlLogix
High Speed Counter M odule
This chapter describes how to configure the ControlLogix High Speed
Counter module. The following table describes what this chapter
contains and its location.
For information about:
Configuring Your High Speed Counter
Module
Overview of the Configuration Process
Creating a New Module
Using the Default Configuration
Altering the Default Configuration
High Speed Counter Data Structures
Accessing the Tags
Changing Configuration Information at the
Tags
Downloading Configuration Data
Using Ladder Logic
Using Message Instructions
Creating a New Tag
Configuring HSC Modules in a Remote
Chassis
Chapter Summary and What's Next
You must configure your module upon installation, either by using the
module's default configuration or altering the default configuration for
your specific application. The module will not work until it has been
configured.
RSLogix 5000 Configuration Softw are
Use RSLogix 5000 software to write initial configuration for your HSC
module. After module operation has begun, you must use ladder
logic, and message instructions, to change module configuration.
Chapter
See page:
5-1
5-2
5-3
5-2
5-2
5-7
5-17
5-18
5-19
5-20
5-22
5-23
5-26
5-28
Publication 1756-UM 007A-EN-P - October 2000
5