WORLD-BEAM QS30 LLP and LLPC
SETUP Mode
SETUP mode is accomplished via the sensor's two push buttons.
It is used to change sensor output response for:
• Light or Dark Operate
• 30-millisecond pulse stretcher (OFF-delay), if required.
The status LEDs, active only during SETUP mode, indicate the
output response configuration when the sensor will be in RUN
mode.
0.04 seconds < T < 0.8 seconds
Access SETUP
• Press and hold both push but-
Mode
tons > 2 seconds
Select SETUP
• Click either push button to toggle
Options
through the four possible setting
combinations.
Return to RUN
• Press and hold both push but-
Mode
tons > 2 seconds
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Push Button
• Green Power LED turns OFF
or
• Green Power LED turns ON
SETUP
status
indicators
Figure 5. SETUP Mode
Result
—
GAIN
—
+
DO, No Delay
—
+
LO, 30 ms Delay
—
GAIN
GAIN
8
7
6
5
4
4
3
3
DO
2
2
LO
1
1
+
—
+
DO 30 ms Delay
—
+
LO, No Delay
+