Banner Q5Z Quick Start Manual

Q5Z Global Laser Measurement Sensor with
IO-Link Quick Start Guide

Product Description

Laser sensor with dual outputs and IO-Link
This guide is designed to help you set up and install the Q5Z Global Laser Measurement Sensor. For complete information on programming,
performance, troubleshooting, dimensions, and accessories, please refer to the Instruction Manual at www.bannerengineering.com. Search
for part number 226330 to view the Instruction Manual. Use of this document assumes familiarity with pertinent industry standards and prac­
tices.
WARNING:
• Do not use this device for personnel protection
• Using this device for personnel protection could result in serious injury or death.
• This device does not include the self­checking redundant circuitry necessary to allow its use in personnel safe­
ty applications. A device failure or malfunction can cause either an energized (on) or de-energized (off) output
condition.

Overview

The Q5Z Global Laser Measurement Sensor is a Class 2 laser sensor with IO­Link and a multifunction output.
The single teach button and no display mean the sensor must be configured at the factory. This is so that it is ready for installation out of the
box. To customize the configuration for an application, contact Banner Engineering.
Class 2 Laser Description and Safety Information
Read the following safety information for proper use of a Class 2 laser.
CAUTION:
• Return defective units to the manufacturer.
• Use of controls or adjustments or performance of procedures other than those specified herein may result in
hazardous radiation exposure.
• Do not attempt to disassemble this sensor for repair. A defective unit must be returned to the manufacturer.
CAUTION:
• Never stare directly into the sensor lens.
• Laser light can damage your eyes.
• Avoid placing any mirror-like object in the beam. Never use a mirror as a retroreflective target.
Class 2 lasers are lasers that emit visible radiation in the wavelength range from 400 nm to 700 nm, where eye protection is normally afford­
ed by aversion responses, including the blink reflex. This reaction may be expected to provide adequate protection under reasonably fore­
seeable conditions of operation, including the use of optical instruments for intrabeam viewing.
Low-power lasers are, by definition, incapable of causing eye injury within the duration of a blink (aversion response) of 0.25 seconds. They
also must emit only visible wavelengths (400 to 700 nm). Therefore, an ocular hazard may exist only if individuals overcome their natural
aversion to bright light and stare directly into the laser beam.
Original Instructions
June 23, 2023
For Safe Laser Use - Class 2 Lasers
• Do not stare at the laser.
• Do not point the laser at a person's eye.
• Mount open laser beam paths either above or below eye level, where practical.
• Terminate the beam emitted by the laser product at the end of its useful path.
© Banner Engineering Corp. p/n: 226329 Rev. B
226329