Emerson Rosemount 708 Reference Manual page 2

Revisions
Device
Rosemount 708 Hardware Revision
®
HART Device Revision
Field Communicator Field Device Revision
Rosemount 708 Wireless Acoustic Transmitter safety messages
NOTICE
Read this manual before working with the product. For personal and system safety, and for optimum product performance,
ensure you thoroughly understand the contents before installing, using, or maintaining this product.
Customer Central
1-800-999-9307 (7:00 a.m. to 7:00 P.M. CST)
National Response Center
1-800-654-7768 (24 hours a day)
Equipment service needs
International
1-(952) 906-8888
NOTICE
Emerson Wireless Gateway
The Rosemount 708 Transmitter and all other wireless devices should be installed only after the Emerson Wireless Gateway has
been installed and is functioning properly. Wireless devices should also be powered up in order of proximity from the Emerson
Wireless Gateway, beginning with the closest. This will result in a simpler and faster network configuration.
Use caution when making changes to the TCP/IP network settings. If they are lost or entered incorrectly, the Gateway will require a
factory reset. Contact your network administrator for information on the proper TCP/IP network settings.
Shipping considerations for wireless products.
The unit was shipped to you without the power module installed. Remove the power module prior to any re-shipping.
Each power module contains one "D" size primary lithium battery. Primary lithium batteries are regulated in transportation by the
U.S. Department of Transportation, and are also covered by IATA (International Air Transport Association), ICAO (International
Civil Aviation Organization), and ARD (European Ground Transportation of Dangerous Goods). It is the responsibility of the shipper
to ensure compliance with these or any other local requirements. Consult current regulations and requirements before shipping.
The polymer enclosure has surface resistivity greater than one gigaohm and must be properly installed in the wireless device
enclosure. Care must be taken during transportation to and from the point of installation to prevent electrostatic charge build-up.
Power module considerations
Battery hazards remain when cells are discharged.
Potential electrostatic charging hazard
Power modules should be stored in a clean and dry area. For maximum battery life, storage temperature should not exceed 86 °F
(30 °C).
The power module may be replaced in a hazardous area. The power module has surface resistivity greater than one gigaohm and
must be properly installed in the wireless device enclosure. Care must be taken during transportation to and from the point of
installation to prevent electrostatic charge build-up.
2
Revision
1
1
Dev v1, DD v1