Zte ZXHN H1600 Maintenance Management Manual page 13

LED Indicator
Broadband
(DSL)
Broadband
(WAN)
Internet
2.4G
5G
WPS
SJ-20200218145027-006 | 2021-03-04(R1.0)
Status
Off
Solid green
Flashing slowly green
Flashing fast green
Off
Solid green
Off
Solid green
Solid red
Flashing green
Off
Solid green
Flashing green
Off
Solid green
Flashing green
Off
Description
The DSL connection has not been established.
DSL synchronization is normal and the link Connection
is normal.
Physical link exists, however carrier wave has not been
detected.
The device is in the handshaking process to establish
the link connection.
The equipment is not powered on or the WAN port is
disabled.
The Ethernet connection has been established.
The gateway is switched off.
The WAN connection is online. The device has a WAN
IP address from IPCP, DHCP or statically configured.
LED remains green in the case of disconnection due
to idle timeout when PPP dial-on-demand is enabled.
Green LED indicates that the routing connection state is
up.
The WAN connection is dialing up or fails to get online.
Device attempted to become IP connected and failed (
no DHCP response, no PPPoE response, PPP authenti-
cation failed, no IP address from IPCP, etc).
The Internet connection has been established and the
data is being transmitted or received.
WLAN RF switch is off.
WLAN RF switch is on.
WLAN RF switch is on and the data is being transmitted
or received, and the flashing frequency indicates Wi-Fi
network traffic.
WLAN RF switch is off.
WLAN RF switch is on.
WLAN RF switch is on and the data is being transmitted
or received, and the flashing frequency indicates Wi-Fi
network traffic.
No WPS access or the WPS access of the terminal ex-
ceeds 5 minutes.
2 Product Overview
2-5