2�4 Ambient Conditions For Storage And Transport; 2�5 Hazards And Warnings; 2�5�1 General Information; Specific Information - Renfert EASY view+3D Original Instructions Manual

2.4 Ambient conditions for storage and transport
For storage and transport, the following ambient conditions must be maintained:
• ambient temperature of -20 – +60 ºC [-4 – +140 ºF],
• maximum relative humidity 80 %�
2.5 Hazards and Warnings
2.5.1 General information
► Granted protection is not given any longer in case the unit is not operated according to the in-
struction manual on hand.
► The unit should only be operated using a mains cable with a country-specific plug system. Any
modification required should only be carried out by an electrician.
► The unit should only be operated if the data on the rating plate corresponds with the data of re-
gional mains voltage.
► The unit should only be plugged into earthed sockets.
► The mains socket should be easily accessible.
► Disconnect the unit from the mains before working on electrical parts.
► Regularly check connecting cables (such as power cables), hoses and housing (for example, the
control panel) for damage (for example, kinks, tears, porosity) or deterioration due to aging.
Do not operate units with damaged connection cables, hoses or housing parts or other defects!
► Damaged equipment must be taken out of service immediately. Disconnect from mains and secure
against being switched on again. Send the device in for repair!
► Operate the equipment only under supervision.
► Observe national accident prevention regulations!
► It is the responsibility of the operator that national regulations during operation and regarding a
repeated safety inspection of electrical equipment are complied with.
For Germany these are the regulation 3 by DGUV (German Statutory Accident Insurance) in rela-
tion with VDE 0701-0702 (Association for Electrical, Electronic and Information Technology).
► Information on REACH and SVHC is available on our website www.renfert.com, in the Support
area.
2.5.2

Specific information

► Do not look into the lighting.
► As with all optical magnification systems, working with the system for long periods can lead to
symptoms of fatigue. Take breaks regularly.
► The 3D glasses do not replace protective eye equipment in any way.
Further safety instructions for the monitor can be found in chapter 6.
When using your own monitor, please follow its safety instructions!
2.6 Approved personnel
The appliance may only be operated and serviced by trained personnel�
Repairs that are not specified in these operating instructions should only be carried out by an electrician.
2.7 Liability Exclusion
Renfert GmbH is not liable for claims for compensation or claims under guarantee if:
► the product is used for purposes other than those stated in the operating instructions
► the product is modified in any way – apart from modifications described in the operating instruc-
tions
► the product has not been repaired by a specialist firm or original Renfert replacement parts have
not been used
► there is continued use of the product despite obvious safety defects or damage
► the product has been subjected to mechanical knocks or has been dropped.
- 5 -
en