Table of Contents
Advertisement
Check Electrolyte Level
1. Shut off the engine.
2. Lockout/tagout the roller as per the site
specific procedure.
3. Check the electrolyte level and keep the
electrolyte level above the plates. Fluid level
is low when below ring or ring is visible and
too high when slots are not visible.
4. Refill with distilled water, if necessary.
Over filling can cause poor performance
!
or early failure.
5. Remove lockout / tagout.
Figure 7-7: Battery Location
A
Battery location
Maintenance
Fuel Tank
Refuel the tank every day before starting the
roller.
1. Unscrew the lockable tank cap.
2. Fill diesel fuel to the lower edge of the filler
pipe.
Check fuel tanks and fuel lines for possible leaks.
Because of the potential fire hazard, leaks must
be corrected as soon as they are spotted.
Fuel is flammable. May cause serious
!
injury or death. Shut off the engine,
extinguish all open flames, and do not
smoke while filling the fuel tanks. Always
wipe up any spilled fuel immediately.
•
Check the fuel level by reading the fuel level
gauge.
•
Never allow fuel tanks to completely empty.
N o t e
Fill tank with the correct grade of fuel.
The fuel tank holds 250 liters.
Figure 7-8: Fuel Tank
A
Fuel tank
66
Advertisement
Table of Contents
