Mellanox Technologies TX6100 MetroX Series Hardware User Manual page 52

Rev 1.1
4. If the switch does not come on, check the power supplies.
5. If the switch comes on, Use the MLNX-OS™ management CLI to determine the cause of the
Shutdown.
6. Check the temperature.
7. Check the Fan status.
The switch is not working and unresponsive:
1. Reset the switch.
If resetting the switch does not work:
2. Unplug the switch.
3. Wait 5 minutes.
4. Plug in the switch.
5. If the switch does not come on, check the power supplies.
6. If the switch comes on, use the MLNX-OS management CLI to determine the cause of the
shutdown.
The last software update did not succeed:
1. Connect the RS232 connector (CONSOLE) to a laptop.
2. Push the reset button on the switch or management module.
3. You will have ~ 5 seconds to stop the U-Boot by pressing Control-B.
4. Choose the image to upload. Only use image 1 or image 2.
U-Boot 2009.01-mlnx1.4 (May 12 2010 - 14:08:15)
CPU:
Board: Mellanox PPC460EX Board
FDEF:
I2C:
DRAM:
FLASH: 16 MB
NAND:
PCI:
PCIE0: link is not up.
52 Mellanox Technologies
AMCC PowerPC 460EX Rev. A at 1000 MHz (PLB=200, OPB=100,
EBC=100 MHz)
Security/Kasumi support
Bootstrap Option H - Boot ROM Location I2C (Addr 0x52)
Internal PCI arbiter disabled
32 kB I-Cache 32 kB D-Cache
No
ready
2 GB (ECC enabled, 400 MHz, CL3)
1024 MiB
Bus Dev VenId DevId Class Int
Troubleshooting