Mellanox Technologies TX6100 MetroX Series Hardware User Manual page 36

Rev 1.1
Table 11 - Configuration Wizard Session - IP Configuration by DHCP (Sheet 2 of 2)
Wizard Session Display (Example)
Step 5: Admin password (Press <Enter> to leave
unchanged)? <new_password>
Step 6: Confirm admin password? <new_password>
You have entered the following information:
1. Hostname: <switch name>
2. Use DHCP on mgmt0 interface: yes
3. Enable IPv6: yes
4. Enable IPv6 autoconfig (SLAAC) on mgmt0
interface: no
5. Admin password (Enter to leave unchanged):
(CHANGED)
To change an answer, enter the step number to return
to.
Otherwise hit <enter> to save changes and exit.
Choice: <Enter>
Configuration changes saved.
To return to the wizard from the CLI, enter the "con-
figuration jump-start" command from configuration
mode. Launching CLI...
<switch name> [>
36 Mellanox Technologies
Comments
To avoid illegal access to the machine, please type a
password and then press <Enter>. Then confirm the
password by re-entering it.
Note that password characters are not printed.
The wizard displays a summary of your choices and
then asks you to confirm the choices or to re-edit them.
Either press <Enter> to save changes and exit, or enter
the configuration step number that you wish to return
to.
Note:
To run the command "configuration jump-start" you
must be in Config mode.
Installation