Coffee Dose And Tamping; Purging The Group Head; Trimming The Dose; Inserting The Portafilter - Sage Bambino Plus User Manual

Hide thumbs Also See for Bambino Plus:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

PAGE HEADER.....
OPERATING YOUR NEW APPLIANCE

COFFEE DOSE AND TAMPING

• Insert the filter basket into the portafilter.
• Grind enough coffee to fill the filter basket.
• Tap the portafilter several times to collapse
and distribute the coffee evenly in the
filter basket.
• Using the tamper, tamp down firmly (approx.
15-20kgs of pressure). The amount of
pressure is not as important as the consistent
pressure every time.
• As a guide, the top edge of the cap on the
tamper should be level with the top of the filter
basket AFTER the coffee has been tamped.
NOTE
Use Razor™ dose trimming tool to
precisely control the dose of ground coffee
AFTER you tamp.

TRIMMING THE DOSE

The Razor™ precision dose trimming tool
allows you to trim the puck to the right level
for a consistent extraction.
Razor
the
Precision dose trimming tool
• Insert the Razor™ tool into the coffee basket
until the shoulders of the tool rest on the rim
of the basket.
• Rotate the Razor™ dosing tool back and forth
while holding the portafilter on an angle over
the knock box to trim off excess coffee grinds.
Your coffee filter is now dosed with the correct
amount of coffee.
10
• Wipe excess coffee from the rim of the filter
basket to ensure a proper seal is achieved
in the group head.

PURGING THE GROUP HEAD

Before placing the portafilter into the group
head, run a short flow of water through the
group head by pressing the 1 CUP button. This
will stabilise the temperature prior to extraction.

INSERTING THE PORTAFILTER

Place the portafilter underneath the group head
so that the handle is aligned with the INSERT
position. Insert the portafilter into the group
head and rotate the handle towards the centre
until resistance is felt.
INSERT
Place your cup/s under the portafilter on the drip tray.
PRE-PROGRAMED SHOT VOLUME
– 1 CUP
Press the 1 CUP button once, the button will flash
indicating that it has been selected. A preset single
espresso volume of approximately 30mls will be
extracted. The machine will automatically stop
once the pre-set volume has been extracted.
LOCK

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ses500

Table of Contents