Dismantling And Rinsing The Fine Foam Frother; Inserting/Changing The Filter - Jura E6 Instructions For Use Manual

7 Maintenance
Dismantling and rinsing the
fine foam frother

Inserting/changing the filter

22
Turn the switch to the x position�
T
The fine foam frother and the milk pipe are rinsed with fresh
water�
'Close switch'
Turn the switch to the ° position�
T
If insufficient foam is produced when the milk is frothed or milk
sprays out of the fine foam frother, this may get dirty� If this hap-
pens, dismantle and rinse the fine foam frother�
Remove the milk pipe and rinse it thoroughly under running
T
water�
Carefully pull the fine foam frother down and off�
T
Dismantle the fine foam frother into its individual parts�
T
Rinse all the parts under running water� If there are severely
T
dried-on milk residues, firstly immerse the individual parts in a
solution of 250 ml water and one dosing unit of JURA milk
system cleaner� Then rinse the individual parts thoroughly�
Re-assemble the fine foam frother�
T
E Ensure that all individual parts are correctly and firmly
connected to ensure optimum operation�
Reattach the fine foam frother to the connector�
T
Once the filter cartridge stops working (depending on the water
hardness setting), the E6 will prompt you to change the filter�
E Your E6 no longer has to be descaled if you are using the
CLARIS Smart filter cartridge�
E CLARIS Smart filter cartridges are available from specialised
dealers�
Precondition: The start screen is displayed� (Alternatively, the filter
symbol $ is displayed in red in the cockpit if the filter's capacity has
been exhausted�)
Remove and empty the water tank�
T
Turn the filter cartridge anticlockwise and remove it along with
T
the extension from the water tank�
Fit the filter cartridge extension on top of a new CLARIS Smart
T
filter cartridge�
Insert the filter cartridge with its extension into the water tank�
T