Dismantling And Rinsing The Fine Foam Frother - Jura E6 Instructions For Use Manual

Dismantling and rinsing the
fine foam frother
Pour one dosing unit of milk system cleaner into the container
T
for milk system cleaning.
Then fill with warm water up to the upper mark.
T
Place the container under the fine foam frother.
T
Connect the milk pipe to the container.
T
E To connect the milk pipe to the container correctly, the pipe
must be fitted with a connector.
Press the 'Next' button.
T
As soon as the machine has heated up,
Turn the switch to the x position.
T
The fine foam frother and the milk pipe are cleaned.
'Close switch'
Turn the switch to the ° position.
T
'Fresh water'
Rinse the container thoroughly and fill the front part with fresh
T
water up to the upper mark.
Place the container under the fine foam frother and reconnect
T
the milk pipe to the container.
Press the 'Next' button.
T
'Open switch'
Turn the switch to the x position.
T
The fine foam frother and the milk pipe are rinsed with fresh
water.
'Close switch'
Turn the switch to the ° position.
T
If insufficient foam is produced when the milk is frothed or milk
sprays out of the fine foam frother, this may get dirty. If this
happens, dismantle and rinse the fine foam frother.
Remove the milk pipe and rinse it thoroughly under running
T
water.
Carefully pull the fine foam frother down and off.
T
7 Maintenance
'Open switch' appears.
23