Table of Contents
Advertisement
Window battery cover opened
63
WINDOW
01 Tamper
Installing the Door/Window Detector
Installing for LP-122 :
To install a Door/Window Detector, follow these steps:
1. Before installing the sensor, to ensure the sensor has learned in main console
successfully
2. Apply double aided adhesive tape to the back of the sensor.
3. Find the arrow embossed on the sensor, just below the LED light. Find a similar arrow
on the magnet. Before exposing the adhesive backing, align the two arrows on the
surface where you want them installed. Check that both parts of the device fit and that
they can be mounted with a gap less than 1/4 inch between them.( refer to below
picture).
4. When finished the above procedure, please reconfirm the setting is correct or not, in
main console, Press the CHECK button then open the window. The main console will
receive the sensor signal and leave some messages on LCD display.
Installing for LP-123 :
To install a Door/Window Detector, follow these steps:
1. Before installing the sensor, to ensure the sensor has learned in main console
successfully
2. You can select the double aided adhesive tape or screw to install the sensor.
3. If you use the double aided adhesive tape to install the sensor, please refer to LP-122
installing process 2 - 4 to set the sensor.
4. If you use the rivet and screw to install the sensor, please follow the step
Please use the fix sticker on the wall and pinch two holes to install the rivet and screws
5. Use LP-123 back cover with two holes to put on the screws.
6. Use the magnet to set near the door/window frame. Find the arrow embossed on the
sensor, just below the LED light. Find a similar arrow on the magnet. Before exposing
the adhesive backing, align the two arrows on the surface where you want them
installed. Check that both parts of the device fit and that they can be mounted with a
gap less than 1/4 inch between them.( refer to below picture)
7. When finished the above procedure, please reconfirm the setting is correct or not, in
main console, Press the CHECK button then open the window. The main console will
receive the sensor signal and leave some messages on LCD display.
Door battery cover opened
SENSOR
23
63
DOOR
SENSOR
01 Tamper
Advertisement
Table of Contents
